Hydro-logic PS-200 PANEL MOUNT DUAL TDS CONTROLLER/MONITOR Manual de usuario descargar pdf (Pagina 2)

2 7

Thank you for purchasing HM Digital’s PS-200. The PS-200 is a panel mount total dissolved solids (TDS)

controller that monitors and controls levels of TDS in water. The controller has a maximum set point to

help maintain a limit of TDS allowed in the product water, as well as a second sensor to monitor the TDS

level of the feed water. If the TDS level rises to the set point, the controller will activate a warning light,

sound an alarm (optional) and switch the dry contact position from the normal position (to operate a

valve, pump, etc.). Once the TDS level drops below the set point, this will deactivate the light and alarm

and switch the contacts back to the normal position (normally open or closed). NOTE: The IN mode &

sensor does not have an alarm nor control set point. It is a monitor only.

CONTACT INFO

BOX CONTENTS

SPECIFICATIONS

If you have any problems or questions regarding your controller, please contact HM Digital, Inc.

HM Digital, Inc. [email protected]om

5819 Uplander Way www.tdsmeter.com

Culver City, CA 90230 1-800-383-2777

U.S.A

1. Controller 3. Two sensor cables (grey) 5. Mounting brackets

2. Two sensors (SP-1) 4. Power cord (black) 6. U.S. plug adapter

TDS Range: 0 - 999 ppm (mg/L)

Resolution: 1 ppm

Accuracy: ±2% (of the reading)

Temperature Compensation: Automatic (ATC) (1-60

Calibration: Manual by trimmer pot calibration screw

Set-Point: Single point, controlled by on-screen up/down buttons (to any point within the range)

Set-Point Relay: single, isolated, 2A, Max. 220V, resistive load 100,000 strokes

Relay Control (out sensor only): The unit will open or close a circuit via dry contacts when the

ppm level of the OUT sensor (aka product water) reaches or exceeds the control setting (simple

switch). It can be used to control a pump, solenoid valve or other device.

Relay Voltage: 5V (the connected device needs its own power source)

Alarm: Optional steady beep (set by user)

Probe: ½” NPTF bushing

Cable Length: 3 meter (9.8 ft) shielded cable

Display: Bright tri-color L.E.D.

Power Supply: 110V/230V, ±10% Vac; 50/60Hz

Enclosure: Front and back with ABS

Environment: -10 to 50

C (4 to 122

F); RH max 95% non-condensing

Dimensions: 7.2 x 7.2 x 10.2 cm (2.8 x 2.8 x 4 in.)

Monitor Weight: 476 grams (1 lb 0.8 oz)

THIS PAGE INTENTIONALLY LEFT BLANK

1 2 3 4

Sin comentarios

Hydro-logic PS-200 PANEL MOUNT DUAL TDS CONTROLLER/MONITOR Manual de usuario Pagina 2